FOD-40™ Fiber Optic Drop Splice Closure Kit

The NEW "Shake N'' Seal" FOD-40™ Kits are specifically designed for fiber applications. Uraseal''s FOD-40™ kit protects your fusion splice from moisture and helps to eliminate cable deterioration and other related problems that can lead to signal loss and cable failure.

Uraseal''s "Shake N''Seal" technology is ideally suited for direct burial applications or equivalent by providing a permanent water tight seal. The kit replaces the sheath integrity with a permanent seal around the splice or damaged cable. The kit can be used for adding a length of fiber to a run, or building a branch splice.

The FOD-40™ kits are designed to quickly and permanently encapsulate 1 or 2 fibers. They are the perfect protection in wet or damp areas because they provide a 100% water tight seal. The kits also provide excellent pull-out strength in freeze-thaw situations as well as in high heat environments where expansion/contraction is an issue.

The kits are safe and easy to use and do not require the use of a torch or flame. This proven technology has been used in similar sealing applications for over 30 years without failure.

DRAIN N'' SEAL® MOISTURE BLOCK SYSTEM

When superior ground moisture control is required, Drain N''Seal® pedestal foam products from Uraseal are the products of choice by communciation field technicians. Specifically designed for fiber pedestals to inhibit ground moisture penetratioin, Drain N''Seal® products minimize damage caused by condensation and water.

The unique cell structure provides complex channels that inhibits the penetration of moisture into the pedestal while allowing any condensate or water build up to freely drain from the pedestal in 2-3 minutes. This unique characteritic of Drain N''Seal® products is superior to pea rock and other foam products. Drain N'' Seal® the simple solution for moisture!

Drain N''Seal® pedestal foam kits are easy to use, economical and light weight. After any re-entry work, new material will completely bond to existing foam. Simply ease off the plastic clip and mix by kneading the package. The kit is ready to pour in 60 seconds and starts foaming immediately. The kit comes complete with divided bag, disposable protective gloves and installation instructions.

No special tools are needed. Drain N''Seal® products are recommended for use in all fiber and copper pedestals and vaults. For larger areas, 3.5 gallon kits are available






eXTReMe Tracker
Website Builder - Freestart Premier Websites